Reprogramming Files For DTC P0606 (11-143-14)
Publication date: 2014-06-25Reference number: 11-143-14
REPROGRAMMING FILES FOR DTC P0606
TECHNICAL SERVICE BULLETIN
Reference Number(s): 11-143-14, Date of Issue:
June 25, 2014
| SUBARU: | 2015 Impreza WRX |
APPLICABILITY
2015MY Impreza WRX 2.0L DIT
INTRODUCTION
This bulletin announces the availability of ECM reprogramming files to address DTC P0606 on 2015MY Impreza WRX 2.0L DIT vehicles.
COUNTERMEASURE IN PRODUCTION
This new logic was incorporated into production according to the table below:
| VEHICLE | TRANSMISSION | STARTING VIN | PRODUCTION DATE CHANGE |
|---|---|---|---|
| Impreza WRX | 6MT | E*808788 | May 6, 2014 |
| CVT | E*808765 | April 25, 2014 |
PACK FILE APPLICABILITY
| MODEL / MODEL YEAR | EMISSION SPEC. | TRANS | PAK FILE NAME | New ECM Part Number | Old ECM Part Number | New CID Number |
|---|---|---|---|---|---|---|
| 2015 Impreza WRX 2.0L DIT | FED/CAL | CVT | 22765AG241.pak | 22765AG241 | 22765AG240 | LV9N001C |
| 6MT | 22765AG231.pak | 22765AG231 | 22765AG230 | LV9N002D |
SERVICE PROCEDURE/INFORMATION
NOTE:
SOA now highly recommends connecting the Midtronics GR8 Diagnostic Battery Charger to the vehicle and utilizing the Power Supply Mode feature anytime a vehicle control module is being reprogrammed. Once the GR8 is connected to the vehicle, as long as the battery is fully charged, it takes less than 3 minutes to boot-up the charger, select the Power Supply Mode, and have the battery voltage stabilized and ready for reprogramming.
VERY IMPORTANT: This information is applicable to the Midtronics GR8 Diagnostic Battery Charger ONLY . It does not apply to any other brand/type of "generic" battery charger whatsoever. ONLY the GR8 and its Power Supply Mode feature has been tested and approved by Subaru of America, Inc. (SOA).
- If the GR8 indicates the vehicle's battery must be charged, charge the battery using the GR8 before proceeding to reprogram the vehicle while using the Power Supply Mode.
- Control module failures as a result of battery discharge during reprogramming are not a matter for warranty. Should any DTCs reset after the reprogramming update is performed, diagnose per the procedure outlined in the applicable Service Manual.
WARRANTY/CLAIM INFORMATION
For vehicles within the Basic New Car Limited and/or Emissions Warranty period, this repair may be claimed using the following information:
| LABOR DESCRIPTION | LABOR OPERATION # | FAIL CODE | LABOR TIME |
|---|---|---|---|
| MFI OBDII ECM Reprogramming | A455-288 | UPG-48 | 0.4 |