Read Current Data: Operation

Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.

1. On «Main Menu» display, select {Each System Check}.
2. On «System Selection Menu» display, select {Occupant Detection System}.
3. On «Occupant Detection System» display, select {Current Data Display & Save}.

   The following table is for support data.

   Item	Display	Note
   Front Passenger Seat Status	Empty or Child/Adult or Child	"Adult or Child" when the seat is occupied "Empty or Child" when the seat is unoccupied or when child restraint seat is installed CAUTION: When checking the operating status, be careful of the followings. When the seat is unoccupied: Do not place anything on the seat. Child restraint seat: Install the seat according to its instruction manual. When the seat is occupied: Someone who weighs at least approx. 70 kg (155 lbs) must be seated during the check.

   NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".