LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> BRZ Series.HyperBlue >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Wireless Door Lock Control System (W/O Entry & Start) >> Wireless Door Lock Control System (Without Entry & Start System) >> Customize Function
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Function

  1. Customization of wireless door lock control system
    1. Customization via SSM3
      CAUTION:
      • When a customer requests a function change, check if the function is customizable.
      • Before starting customization, record the current settings.
      • Before performing the troubleshooting procedure for a function, check that the function is set to the initial settings.
      NOTE: Some items may not be displayed depending on the destination and equipment.
      1. Connect the SSM3 to the DLC3.
      2. Turn IG SW to ON.
      3. Turn on the SSM3.
      4. Enter the following menus. [Integ. unit mode]→[Unit customizing]
      5. Referring to the TABLE  below, perform settings.

      Wireless door lock

      WIRELESS DOOR LOCK DISPLAY REFERENCE

      Display Initial setting Function Setting Controller ECM
      [Keyless Control] Yes Settings for the function that allows you to select to lock the door via operation of the electrical key transmitter sub-assembly (Electronic key) Yes or No Main body ECM (multiplex network body ECM)
      [Wireless Buzzer Resp] ON Wireless door lock buzzer response OFF or ON Main body ECM (multiplex network body ECM)
      [Hazard Answer Back] ON When the wireless lock switch of the transmitter is pressed, all hazard warning lights are illuminated simultaneously. All hazard warning lights illuminate twice when the unlock switch is pressed. OFF or ON Main body ECM (multiplex network body ECM)
      [Open Door Warning] ON The buzzer sounds when the lock is pressed while any door is open. OFF or ON Main body ECM (multiplex network body ECM)
      [Unloocking operation] Yes Settings for the function where all doors are unlocked when the electrical key transmitter sub-assembly (Electronic key) is operated twice Yes or No Main body ECM (multiplex network body ECM)
      [Panic Alarm Function] ON Function to activate the anti-theft system when the panic switch of door control transmitter module set sub-assembly is held down for 0.8 second or more. OFF or ON Main body ECM (multiplex network body ECM)
      [Wireless Auto Lock] ON This function turns ON or OFF the wireless auto lock function. OFF or ON Main body ECM (multiplex network body ECM)
      [Auto Lock Time] 60 second Time from unlock to relock using wireless door lock function 30 seconds, 60 seconds, 120 seconds Main body ECM (multiplex network body ECM)
      [Trunk lid unlocking operation] Long press(short) Settings for the method of operation when opening the trunk with the electrical key transmitter sub-assembly (Electronic key) single press/2 times ON/Long press(short)/Long press(long) Main body ECM (multiplex network body ECM)
      [Wireless Buzzer Volume] Level 5 Wireless door lock buzzer volume Level 7, Level 6, Level 5, Level 4, Level 3, Level 2, Level 1, or Level 0 Main body ECM (multiplex network body ECM)