Power Window Regulator Switch Assembly (Installed To The Front Side): Installation

Installation of power window regulator switch assembly
1. Engage the 4 claws and install the power window regulator switch assembly to the front armrest base panel UPR RH.
  
  Fig 1: Locating Power Window Regulator Switch Assembly Claws
  Courtesy of SUBARU OF AMERICA, INC.
Installation of power window regulator switch assembly W/front armrest base panel UPR RH (Refer to ADJUSTMENT )
Installation of front door trim board sub-assembly RH
Install the part in the same manner as LH side. (Refer to ADJUSTMENT )
Installation of door armrest cover RH
Install the part in the same manner as LH side. (Refer to ADJUSTMENT )
Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )