LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> Outback 2.5i Limited >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Security And Locks - Keyless Access (W/Push Button Start) (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC B1577 IMM Control Module EEPROM >> Except For C0 And C5 Models >> Trouble Symptom
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Except For C0 And C5 Models: Trouble Symptom

Engine will not start.

CAUTION: For replacement procedure of keyless access control module, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.
DIAGNOSTICS PROCEDURE

Step Check Yes No
1 CHECK DTC. 
  1. Turn the ignition switch to ON.
  2. Perform the clear memory operation of ECM. < Ref. to CLEAR MEMORY MODE . > < Ref. to CLEAR MEMORY MODE . >
  3. Turn the ignition switch to OFF.
  4. Remove and install the battery.
  5. Turn the ignition switch to ON.
  6. After 5 seconds or more, read DTC. < Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) . >
 Is B1577 displayed? Replace the keyless access control module. < Ref. to KEYLESS ACCESS CONTROL MODULE . > Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
scientia non olet · About LEMON Manuals