Basic Diagnostic Procedure: Procedure
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 PERFORM CUSTOMER INTERVIEW. Using the Check List for Interview, ask the customer the condition of how the trouble occurred. |
Did you interview the customer? | Go to step 2 . | Interview the customer. < Ref. to CHECK , Check List for Interview. > |
| 2 CHECK LAN SYSTEM. Inspect LAN system. < Ref. to PROCEDURE , Basic Diagnostic Procedure. > |
Is there any fault? | Perform the inspection according to the diagnosis for LAN system. | Go to step 3 . |
| 3 CHECK POWER SEAT MEMORY SYSTEM. Using the Subaru Select Monitor, read DTC of power seat memory system. < Ref. to OPERATION , Read Diagnostic Trouble Code (DTC). > |
Is DTC displayed? | Perform the diagnosis according to DTC. < Ref. to LIST , List of Diagnostic Trouble Code (DTC). > After the repair, Go to step 5 . | Go to step 4 . |
| 4 CHECK THE LIST OF TROUBLE SYMPTOMS. Check "TROUBLE SYMPTOM" for the power seat system. < Ref. to TROUBLE SYMPTOM , INSPECTION, Power Seat System. > |
Does the symptom apply? | Perform the diagnosis according to the inspection procedures. | Currently, system is normal. The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
|
| 5 PERFORM INSPECTION MODE. Perform the Inspection Mode. < Ref. to INSPECTION MODE . > |
Is DTC displayed? | Perform the diagnosis according to DTC. < Ref. to LIST , List of Diagnostic Trouble Code (DTC). > | Finish the diagnosis. |