Basic Diagnostic Procedure: Procedure
| Step | Check | Yes | No |
|---|---|---|---|
| 1 PERFORM CUSTOMER INTERVIEW. Using the Check List for Interview, ask the customer the condition of how the trouble occurred. |
Did you interview the customer? | Go to step 2 . | Interview the customer. Ref. to CHECK , Check List for Interview. |
| 2 CHECK LAN SYSTEM. Inspect LAN system. Ref. to PROCEDURE , Basic Diagnostic Procedure. |
Is the check result OK? | Go to step 3 . | Perform the inspection according to the diagnosis for LAN system. |
| 3 CHECK POWER SEAT MEMORY SYSTEM. Using the Subaru Select Monitor, read DTC of power seat memory system. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC). |
Are any DTCs displayed? | Perform the diagnosis for the displayed DTCs. Ref. to LIST , List of Diagnostic Trouble Code (DTC). After the repair, Go to step 5 . | Go to step 4 . |
| 4 CHECK THE LIST OF TROUBLE SYMPTOMS. Check "TROUBLE SYMPTOM" for the power seat system. Ref. to TROUBLE SYMPTOM , INSPECTION, Power Seat System. |
Does the symptom apply? | Perform the diagnosis according to the inspection procedures. | Currently, system is normal. The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
|
| 5 PERFORM INSPECTION MODE. Perform the Inspection Mode. Ref. to INSPECTION MODE . |
Are any DTCs displayed? | Perform the diagnosis for the displayed DTCs. Ref. to LIST , List of Diagnostic Trouble Code (DTC). | Finish the diagnosis. |