DTC P0336: Crankshaft Position Sensor "A" Circuit Range/Performance: Notes
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
TROUBLE SYMPTOM:
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to
OPERATION
, Clear Memory Mode, and Inspection Mode Ref. to
PROCEDURE
, Inspection Mode.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2 | Tighten the crankshaft position sensor installation bolt securely. Ref. to INSTALLATION , Crankshaft Position Sensor. |
| 2 CHECK CRANKSHAFT POSITION SENSOR PLATE. | Is there crack or damage in the crankshaft position sensor plate teeth? | Replace the crankshaft position sensor plate. Ref. to CYLINDER BLOCK | Go to step 3 |
| 3 CHECK INSTALLATION CONDITION OF TIMING CHAIN. Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 18252AA000 CRANKSHAFT SOCKET |
Is the timing chain dislocated from its proper position? | Correct the installation condition of timing chain. Ref. to TIMING CHAIN ASSEMBLY | Replace the crankshaft position sensor. Ref. to CRANKSHAFT POSITION SENSOR |