DTC P05A1: Active Grille Air Shutter "A" Position Sensor Minimum/Maximum Stop Performance: Notes
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to
OPERATION
, Clear Memory Mode, and Inspection Mode Ref. to
PROCEDURE
, Inspection Mode.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK ACTIVE GRILLE SHUTTER. Check the area around the active grille shutter louver, louver link and actuator. |
Is there any abnormality such as a foreign matter adhered or pinched and a frost? | Remove the foreign matter from the active grille shutter. | Go to step 2 |
| 2 CHECK ACTIVE GRILLE SHUTTER. Check the area around the active grille shutter louver, louver link and actuator. |
Is there any damage in each part of the active grille shutter? | Replace the active grille shutter. Ref. to ACTIVE GRILLE SHUTTER | Go to step 3 |
3 CHECK ACTIVE GRILLE SHUTTER.
NOTE:
For detailed operation procedures, refer to the "Active Test". Ref. to
ACTIVE TEST
|
Does the open/close operation finish correctly? | Even if DTC is detected, it has returned to a normal condition at this time.
NOTE:
In this case, it is assumed that the active grille shutter may have temporarily had a foreign matter adhered/pinched or a frost.
|
Replace the active grille shutter. Ref. to ACTIVE GRILLE SHUTTER |