Oil Pressure Switch: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

Apply seal material to the bolt threads of oil pressure switch, and install the oil pressure switch.
NOTE:
Before applying the seal material, degrease the oil pressure switch and the thread portions of the chain cover.

Seal material:

THREE BOND 1324 (part No. 004403042) or equivalent

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Connect the terminal, and attach the rubber cap.
NOTE:
Fix the terminal within the range of 90° as shown in the figure.

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

1.5 N.m (0.2 kgf-m, 1.1 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Check the engine oil level and replenish the engine oil if necessary. Ref. to LUBRICATION (H4DOTC)>ENGINE OIL>INSPECTION .