October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
At Select Lever Assembly
- Remove the spacer plate.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the gasket.
Courtesy of SUBARU OF AMERICA, INC.
- Insert a flat tip screwdriver with a thin tip under the connector and disconnect the harness connector.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the harness.
Courtesy of SUBARU OF AMERICA, INC.
- Raise the claw with a flat tip screwdriver with a thin tip and remove the solenoid unit.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the terminal of the solenoid unit using a flat tip precision screwdriver with a tip width of 1.3 mm (0.05 in) or less, KTC connector terminal tool ECC-1T or equivalent.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the clamp push nut.
NOTE:
Replace the clamp push nut with a new part.
Courtesy of SUBARU OF AMERICA, INC.
- Pull out shaft control.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the clamp push nut.
NOTE:
Replace the clamp push nut with a new part.
Courtesy of SUBARU OF AMERICA, INC.
- Pull out spacer pin guide.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the clamp pin.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the spacer pin guide.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the select lever COMPL.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the arm COMPL.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the plate guide.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the rod detent and the detent spring.
Courtesy of SUBARU OF AMERICA, INC.