VDC Control Module Parameter Check

NOTE: The parameter data registered in the VDC CONTROL MODULE is shown on the display.

Perform confirming on parameter.
1. Connect the Subaru Select Monitor to data link connector.
  NOTE: For detailed operation procedures, refer to "Application help".
2. Turn the ignition switch to ON.
3. On <<Start>> display, select <<Diagnosis>>.
4. On <<Vehicle selection>> display, input the target vehicle information and select <<Confirmed>>.
5. On <<Main Menu>> display, select <<Each System>>.
6. On <<Select System>> display, select <<Brake Control System>> and select <<Enter>>.
7. On <<Select Function>> display, select <<Work Support>>.
8. On <<Work Support>> display, select <<Confirm on parameter>>.
Check that the applied model and grade of the relevant vehicle are included, and click the <<OK>> button.
If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>MAINTENANCE MODE>VDC CONTROL MODULE PARAMETER SELECTION .