DTC P2017: TGV Position Sensor/Switch Circuit High Bank 1: Notes

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

• Improper idling
• Engine stalls.
• Poor driving performance

Wiring diagram: 

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK CURRENT DATA  .
   1. Start the engine.
   2. Read the value of «TGV Position Sensor R» using the Subaru Select Monitor.
      NOTE: For detailed operation procedures, refer to "Read Current Data For Engine". Ref. to ENGINE (DIAGNOSTICS) (STI)>Subaru Select Monitor .

   Is the value of «TGV Position Sensor R» 5 V or more?

   Yes: Go to  2.

   NO: Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK HARNESS BETWEEN ECM AND TUMBLE GENERATOR VALVE ASSEMBLY RH CONNECTOR  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from tumble generator valve assembly RH.
   3. Start the engine.
   4. Read the value of «TGV Position Sensor R» using the Subaru Select Monitor.
      NOTE: For detailed operation procedures, refer to "Read Current Data For Engine". Ref. to ENGINE (DIAGNOSTICS) (STI)>Subaru Select Monitor .

   Is the value of «TGV Position Sensor R» 5 V or more?

   Yes: Repair the short circuit to power in harness between ECM connector and tumble generator valve assembly RH connector.

   No: GO to  3.

3. CHECK HARNESS BETWEEN ECM AND TUMBLE GENERATOR VALVE ASSEMBLY RH CONNECTOR  .
   1. Turn the ignition switch to OFF.
   2. Measure the resistance of harness between tumble generator valve assembly RH connector and engine ground.

      Connector & terminal

      (E55) No. 2 - Engine ground:

   Is the resistance less than 5 Ω?

   Yes: Go to  4.

   NO: Repair the harness and connector.

   NOTE: In this case, repair the following item:

   • Open circuit in harness between ECM connector and tumble generator valve assembly RH connector
   • Poor contact of ECM connector
   • Poor contact of coupling connector
4. CHECK FOR POOR CONTACT  .

   Check for poor contact of tumble generator valve assembly RH connector.

   Is there poor contact of the tumble generator valve assembly RH connector?

   Yes: Repair the poor contact of tumble generator valve assembly RH connector.

   No: Replace the tumble generator valve assembly RH. Ref. to FUEL INJECTION (FUEL SYSTEMS) (STI)>Tumble Generator Valve Assembly .