LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Forester Touring >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System >> Camshaft Position Sensor >> Inspection >> Camshaft Position Sensor
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Camshaft Position Sensor

  1. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Prepare an oscilloscope.
  3. Disconnect the connector from ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>ENGINE CONTROL MODULE (ECM)>REMOVAL .
  4. Attach the ST between the ECM, engine wiring harness and the bulkhead wiring harness. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>GENERAL DESCRIPTION>PREPARATION TOOL>HOW TO USE CHECK BOARD .

    Special tool: 

    CHECK BOARD (18460AA180)

  5. Connect the probe to ST.
    G13223954Courtesy of SUBARU OF AMERICA, INC.
    Camshaft position sensor Terminals No. Probe
    Intake RH (E158) No. 78 +
    LH (E158) No. 77 +
    Exhaust RH (E158) No. 65 +
    LH (E158) No. 64 +
    RH and LH (B134) No. 69 -
  6. Start the engine and let it idle.
  7. Check the waveforms and voltage.
    NOTE: For waveform and voltage, refer to "Control Module (ECM) I/O Signal". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>CONTROL MODULE I/O SIGNAL .
  8. After inspection, install the related parts in the reverse order of removal.
NOTE: For installation procedures of ECM connectors, refer to Engine Control Module (ECM). Ref. to INSTALLATION .
scientia non olet · About LEMON Manuals