DTC B2352: Radar ASSY B&S Reprogramming Error
The radar sensor stops when the reprogramming for control module other than the control module of radar sensor is operated.
NOTE:
It is normal if the operation returns after the ignition switch OFF → ON operation, following finishing of the reprogramming procedure.
After the normal recovery, perform the clear memory operation. Ref. to BLIND SPOT DETECTION/REAR CROSS TRAFFIC ALERT (DIAGNOSTICS)>Clear Memory Mode>OPERATION .
After the normal recovery, perform the clear memory operation. Ref. to BLIND SPOT DETECTION/REAR CROSS TRAFFIC ALERT (DIAGNOSTICS)>Clear Memory Mode>OPERATION .