Front Sub Switch
- Measure the resistance between terminals of the switch assembly power window front sub.
Preparation tool:
Circuit tester
- Passenger's seat sub
Terminal No. Inspection conditions Standard 6-5 OFF Less than 1 Ω 2 - 1
2 - 5
2 - 61 MΩ or more 2-6 Manual UP Less than 1 Ω 5-6
2-5
1 - 21 MΩ or more 2-6
1 - 2Auto UP Less than 1 Ω 5-6
2-51 MΩ or more 2-5 Manual DOWN Less than 1 Ω 5-6
2-6
1- 21 MΩ or more 2-5
1 - 2Auto DOWN Less than 1 Ω 5-6
2-61 MΩ or more
- Passenger's seat sub
- Apply battery voltage between the switch power window sub front terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side .
Incorrect polarity connection may cause LED damage inside the switch .
Terminal No. Inspection conditions Standard 7 (+) - 2 (-) Apply battery voltage. Light ON - Replace the switch assembly power window front sub if it is found defective from the inspection result.