Hazard Switch: Inspection
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the resistance between connector terminals.
Terminal No. Inspection conditions Standard 3 - 2 Switch OFF 1 MΩ or more Switch ON Less than 1 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.
Terminal No. Inspection conditions Specification 4 (+) - 1 (-) Apply battery voltage. Light ON - Replace the switch hazard if it is found defective.