October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Select Lever: Removal
- Shift the select lever to "N" range.
- Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY
.
NOTE:
For model with battery sensor, disconnect the ground terminal from battery sensor.
- Lift up the vehicle.
- Remove the center exhaust pipe (rear). Refer to EXHAUST(W/O STI)>CENTER EXHAUST PIPE>REMOVAL
.
- Remove the center exhaust cover.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Disconnect the cable from the arm COMPL.
CAUTION:
Do not apply extra overload while holding the part (a).
 Courtesy of SUBARU OF AMERICA, INC.
|
 Courtesy of SUBARU OF AMERICA, INC.
|
- Raise the claw of clamp and remove the cable.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Lower the vehicle.
- Shift the select lever to "N" range.
- Lower the boot assembly vertically toward the lever.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the clamp grip pin.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the grip assembly.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the console box assembly. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL
.
- Remove the cover - shift lever. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL
.
- Remove the panel center LWR LH and RH. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL
.
- Disconnect the connector, and remove the indicator assembly.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the harness clips.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Disconnect the harness connector.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the select lever assembly.
 Courtesy of SUBARU OF AMERICA, INC.
|