LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> WRX Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transmission (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0965: Pressure Control Solenoid "B" Control Circuit Range/Performance >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0965: Pressure Control Solenoid "B" Control Circuit Range/Performance: Notes

1. - 

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

Wiring diagram: 

CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM>WIRING DIAGRAM

G14613613Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
  1. CHECK DTC  .

    Read the DTC of [Transmission] using the Subaru Select Monitor. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) 

    Besides DTC P0965, is DTC P0720, P0966, P0967, or P2751 displayed?

    Yes  : Perform the diagnosis according to DTCs other than P0965. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST 

    No  : Go to  2.

  2. CHECK F & R SOLENOID (ACTIVE TEST)  .
    1. Turn the ignition switch to ON.
    2. Using the Subaru Select Monitor, perform the active test for F & R solenoid. Ref. to TRANSMISSION (DIAGNOSTICS)>ACTIVE TEST 

    Is 300 → 500 → 700 mA indicated at the active test, and does [Actual Forward & Reverse Linear Solenoid Current] follow [Commanded Forward & Reverse Linear Solenoid Current]?

    Yes  : Go to  3.

    No  : Go to  4.

  3. CHECK FOR POOR CONTACT  .

    Check for poor contact of harness and connector between TCM and F & R solenoid.

    Is there poor contact?

    Yes  : Repair the poor contact of harness and connector.

    No  : Recheck the poor contact of harness and connector. Replace the TCM if no fault is found. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSMISSION CONTROL MODULE (TCM)

  4. CHECK F & R SOLENOID  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the transmission connector.
    3. Measure the resistance between transmission connector and transmission body.

      Connector & terminal 

      (T1) No. 12 - Transmission body:

    Is the resistance approximately 3.5 - 7.1 Ω? (When cold)

    Yes  : Replace the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CONTROL VALVE BODY

    No  : Repair or replace the harness.