April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B260C: Control Module Communication Stuck

DTC detecting condition:

When stuck in register of CAN controller is detected.

Trouble symptom:

Seat memory registration/restoration is unable to be performed.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to POWER SEAT MEMORY (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .

CHECK DTC .
1. Turn the ignition switch to OFF.
2. Disconnect the seat position memory control module connector.
3. Connect the disconnected connectors.
4. Turn the ignition switch OFF → ON.
5. Read the DTC of [Power Seat Memory] using the Subaru Select Monitor. Ref. to POWER SEAT MEMORY (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC B260C displayed? (Current malfunction)

Yes Replace the seat position memory control module. Ref. to SEATS>POWER SEAT SYSTEM .

No Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.