LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2023 >> WRX Base, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System >> Oil Level Switch >> Installation >> When The CROSSMEMBER COMPL Front Was Removed
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

When The CROSSMEMBER COMPL Front Was Removed

  1. Use a new O-ring to install the oil level switch, and secure the harness with the clip.
    NOTE: Apply engine oil to O-ring.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G13199185Courtesy of SUBA
  2. Secure the harness with clip, and connect the connector.
    G13620669Courtesy of SUBA
  3. Install the engine mounting LH.

    Tightening torque: 

    35 N.m (3.6 kgf-m, 25.8 ft-lb)

    G14601534Courtesy of SUBA
  4. Install the crossmember COMPL front. Ref. to FRONT SUSPENSION>CROSSMEMBER>INSTALLATION .
  5. Fill engine oil. Ref. to LUBRICATION (H4DOTC)>ENGINE OIL>REPLACEMENT .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals