Crankshaft Position Sensor: Installation

Install the crankshaft position sensor with new O-ring.
NOTE: Apply engine oil to O-ring.

Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Secure the preheater pipe with the bolt.
Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)
Install the transmission harness to the ATF cooler pipe, and connect the connector. (AT model)
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .