Power Seat & Remote Control Mirror Control Module (Model With Seat Position Memory)

Prior to starting work, check the following precautions. Ref. to SEATS>GENERAL DESCRIPTION>CAUTION .
When replacing the power seat & remote control mirror Control Module with registered memory with a new part, perform the variant work. (Model with seat position memory) Ref. to POWER SEAT MEMORY(DIAGNOSTICS)>WORK SUPPORT>OPERATION .
Operate the switch to move the front seat (driver's seat) to the following positions.
- Slide: rearmost end
- Reclining: most upright
- Lifter: downmost end
- Tilt: downmost end
Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the driver's seat from the vehicle.
Remove the power seat & remote control mirror control module.
1. Disconnect the connector.
2. Remove the nuts and remove the power seat & remote control mirror control module.
  
  Courtesy of SUBARU