Ignition System: Distributor: Installation
- To install, reverse removal procedure. If reference mark was not made as described in removal procedure or if crankshaft has been rotated, go to next step.
- Turn crankshaft (clockwise direction) until cylinder No. 1 is at TDC of compression stroke. Align rotor with center of cap bolt hole. See Fig 1
(STEP 1).
- Before installing distributor, ensure "O" ring is in good condition. Replace as required. If new "O" ring is installed, lubricate with engine oil. Install distributor into gearbox.
- When distributor is fully seated, rotor will point to about the one o'clock position. See Fig 1
(STEP 2).
- Ensure distributor is fully seated. Install distributor hold-down bolt. Adjust ignition timing. See the BASIC TESTING
article.
Courtesy of SUZUKI OF AMERICA CORP.