Speed Sensor Drive With Automatic Transaxle

A/T VEHICLE SPEED SENSOR (A/T VSS)

INSPECTION





1. Disconnect negative cable at battery.
2. Disconnect A/T Vehicle Speed Sensor (VSS) coupler.
3. Check resistance between A/T VSS terminals.

A/T VSS standard resistance: 648 - 792 ohms at 20° C (68° F)

REMOVAL





1. Disconnect negative cable at battery.
2. Disconnect A/T Vehicle Speed Sensor (VSS) coupler.
3. Remove A/T VSS by removing its bolt.

INSTALLATION





1. Apply A/T fluid to A/T Vehicle Speed Sensor (VSS) O-ring.
2. Install A/T VSS to A/T case and tighten bolt to specified torque.

Tightening Torque (a): 5.5 Nm (0.55 kg-m, 4.0 ft. lbs.)

3. Connect A/T VSS coupler to A/T VSS.
4. Connect negative cable to battery.