DTC Troubleshooting
DTC TROUBLESHOOTING CHART
| Step |
Action |
YES |
NO |
| 1 |
Was "Keyless Start System Check" performed? |
Go to Step 2. |
Go to KEYLESS START SYSTEM CHECK . |
| 2 |
Steering lock unit circuit check
- Disconnect connector from keyless start control module.
- Check for proper connection to "Steering lock unit power supply", "Steering lock unit signal" and "Steering lock unit ground" terminals of keyless start control module connector.
- If OK, check for open, short and high resistance in following circuits.
- Steering lock unit power supply circuit
- Steering lock unit signal circuit
- Steering lock unit ground circuit
Is each circuit in good condition? |
Go to Step 3. |
Repair circuit. |
| 3 |
Steering lock unit power supply voltage check
- Connect connector to keyless start control module.
- Measure voltage between "Steering lock unit power supply" terminal of steering lock unit connector and vehicle body ground.
Is voltage 4 - 6 V? |
Replace steering lock unit. |
Substitute a known-good keyless start control module and recheck. |