LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Power Assisted Steering System) >> Diagnostic Information and Procedures >> Power Steering System Pressure Test >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the power steering fluid level and the power steering pump belt tension. Refer to Checking and Adding Fluid  and Serpentine Accessory Drive Belt Installation .
  2. Disconnect the high pressure line at the pump. Use a small container to catch any fluid.
  3. Connect the hose of the pressure test gauge kit KM-354-B to the power steering pressure hose from the power steering pump.
  4. Place the gear selector lever in Park. Set the parking brake.
  5. Open the gauge valve fully.
  6. Start the engine and let it idle.
  7. Turn the steering wheel from lock to lock several times to warm the fluid to operating temperature.
  8. Increase the engine speed to 1,500 rpm.
  9. Close the gauge valve fully, and read the pressure. The pump pressure with the valve closed should be between 8,330 - 8,820 kPa (1,208 - 1,279 psi).
    CAUTION: The power steering pump could be damaged if the valve is fully closed for more than 5 seconds.
  10. Immediately open the gauge valve fully.
  11. Turn the steering wheel all the way to the left and the right. If the pressure is within the specified limits, the problem is not in the pump. Check the power steering gear for leaks.
scientia non olet · About LEMON Manuals