P/S Pump Assembly Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Install the power steering pump into the vehicle and install the 2 long power steering pump bolts.
Tighten:

Tighten the power steering pump bolts to 25 N.m (18 lb-ft).
Swing the power steering pump bracket down and install the front right side bolt.
Tighten:

Tighten both of the right side power steering pump bracket bolts to 35 N.m (26 lb-ft).

Fig 1: Identifying Power Steering Pump & Long Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Connect the supply hose to the power steering pump.
Connect the high-pressure hose fitting to the power steering pump.
Tighten:

Tighten the high-pressure hose fitting to 28 N.m (21 lb-ft).

Fig 2: Identifying Pressure Line Pipe And Supply Line Hose
Courtesy of SUZUKI OF AMERICA CORP.
Install the serpentine accessory drive belt. Refer to Serpentine Accessory Drive Belt Installation .
Refill the power steering fluid. Refer to Checking and Adding Fluid .
Bleed the power steering system. Refer to Bleeding the Power Steering System .

Fig 3: Identifying Wrench And Serpentine Accessory Drive Belt
Courtesy of SUZUKI OF AMERICA CORP.