Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Battery Disconnect Caution .

IMPORTANT: Remote keyless transmitters must be programmed when remote control module/receiver is replaced.

Disconnect the negative battery cable.
Separate the hood release cable from the hood latch release handle.
Carefully pull the instrument panel under cover until the mounting clips are released and the instrument panel under the cover.
Remove the bolts from the driver's side knee bolster.
Disconnect the control module/receiver electrical connector.
Slide the control module/receiver away from its mounting bracket.