Tire Pressure Sensor Learn: Notes
NOTE:
If using the scan tool to enable the learn mode, the Activation Tool (J-46079) must be used to activate the sensors. When this preferred method is used, any stray sensor signals will not affect the learn procedure. In the event a particular sensor's information is displayed on the special tool upon activation but the horn does not chirp, it may be necessary to rotate the wheel valve stem to a different position due to the sensor signal is being blocked by another component.
NOTE:
If using the keyless entry transmitter or DIC buttons to enable the learn mode, the Activation Tool or Pressure Increase/Decrease Method may be used. Before proceeding with this method, ensure that no other learn procedure is being performed simultaneously or that tire pressures are not being adjusted on another TPM equipped vehicle within close proximity. Stray signals from other TPM equipped vehicles just driving by can be inadvertently learned. If any random horn chirps are heard from the vehicle while performing the learn procedure, most likely a stray sensor has been learned and the procedure will need to be cancelled and repeated. Under these circumstances, performing the TPM Learn Procedure away from other vehicles would be highly recommended.
NOTE:
In the event a particular sensor activation does not cause the horn to chirp, it may be necessary to rotate the wheel valve stem to a different position due to the sensor signal being blocked by another component.
Learn Mode can be enabled using either the Keyless Entry System, the Driver Information Center (DIC), or a Scan Tool. See Keyless Entry Or DIC Learn Enable Method or Scan Tool Learn Enable Method .