LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> SX4 4WD L4-2.0L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Engine Control Module >> Testing and Inspection >> Pinout Values and Diagnostic Parameters >> Resistance Check
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Resistance Check

Resistance Check

1. Remove ECM from its bracket referring to Engine Control Module (ECM) Removal and Installation.

CAUTION: Never touch terminals of ECM itself or connect voltmeter or ohmmeter (3).

2. Connect special tool to ECM connectors (1) securely.

NOTE: Do not connect the other connector of special tool to ECM.

Special Tool
(A): 09933-06320

3. Check resistance between each pair of terminals of special tool connectors (2) as listed in the following table.

CAUTION:
^ Be sure to connect ohmmeter probe from wire harness side of coupler.
^ Be sure to turn OFF ignition switch for this check.
^ Resistance in the following table represents that measured when parts temperature is 20 °C (68 °F).







scientia non olet · About LEMON Manuals