LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Security And Locks) >> Diagnostic Information and Procedures >> Liftgate Release Inoperative >> Circuit / System Testing >> Liftgate Switch Malfunction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Liftgate Switch Malfunction

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the liftgate switch.
  2. Ignition OFF, test for less than 1 Ω for resistance between the ground circuit terminal C and ground.
    • If greater than the specified range, test the ground circuit for an open / high resistance.
  3. Ignition ON, verify the scan tool Ext Trunk / Liftglass Rel Sw parameter is Inactive.
    • If not the specified value, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3-A fused jumper wire between the signal circuit terminal A and ground. Verify the scan tool Ext Trunk / Liftglass Rel Sw parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open / high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the liftgate switch.
scientia non olet · About LEMON Manuals