Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
Always route the replacement cable the same way as the original cable.

Fig 1: Battery Cable Clip & Battery Tray Support Bracket
Courtesy of SUZUKI OF AMERICA CORP.

Remove the battery box. Refer to REMOVAL PROCEDURE .
Disconnect the positive and negative battery cable clip (3) from the battery tray support bracket.
Disconnect the positive and negative battery cable clip on the side of the battery tray support bracket.

Fig 2: Battery Cable Electrical Connector, Battery Current Sensor And Body Wiring Harness Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect the negative battery cable electrical connector (7) from the body wiring harness electrical connector (2).
Disconnect the body wiring harness electrical connector (4) from the battery current sensor (5).

Fig 3: Negative Battery Cable Ground Terminal, Nut And Wheelhouse Stud
Courtesy of SUZUKI OF AMERICA CORP.
Remove the negative battery cable ground terminal nut from the wheelhouse stud.
Remove the negative battery cable ground terminal from the wheelhouse stud.

Fig 4: Negative Battery Cable Ground Terminal, Nut And Transaxle Stud
Courtesy of SUZUKI OF AMERICA CORP.
Remove the negative battery cable ground terminal nut (2) from the transaxle stud.
Remove the negative battery cable ground terminal (1) from the transaxle stud.
Cut the tape and remove the negative battery cable from the wiring loom.