Headlight Auto Leveling Control Module
NOTE:
Scan tool data can be read by selecting "Headlight Auto Leveling" menu on SUZUKI scan tool.
As the data values are standard values estimated on the basis of values obtained from the normally operating vehicles using a scan tool, use them as reference values. Even when the vehicle is in good condition, there may be cases where the checked value does not fall within each specified data range. Therefore, judgment as abnormal should not be made depending on these data alone.
DTC TABLE
| Scan tool data | Vehicle condition | Normal condition / Reference value |
| Battery Voltage | Engine: Idle speed | Approx. 12 V |
| Leveling Actuator | Ignition: ON Lighting switch: For 17 sec. After lighting switch is in "ON" position. |
27 - 90% |
| Other than above condition | 0% | |
| Front Height Sensor | Ignition: ON | 490 - 4, 500 mV |
| Rear Height Sensor | Ignition: ON | 490 - 4, 500 mV |
| Vehicle Speed | Vehicle running | Almost the same as speedometer reading |
| Headlight Switch |
|
ON |
|
OFF |