Initialization (When Only Windshield Is Replaced)

Check that vehicle is in the following conditions.
- Ignition mode of keyless push start system is in "OFF".
- Wiper and washer switch is OFF.
- Lighting switch is OFF.
- Wiper is in park positions.
- Temperature around rain / light sensor is 5 to 40 °C (41 to 120 °F).
- Vehicle is stopped.
- Adjustment knob (1) is as shown in figure.
Push engine switch to change ignition mode of keyless push start system to "ON" and wait for 3 seconds.
3) Change position of adjustment knob in sequence of 5 → 4 → 5 → 1→ 5→ 4 → 5 within 7 seconds.

Fig 2: Identifying Adjustment Knob Positions

Courtesy of SUZUKI OF AMERICA CORP.

Check that clearance lights flash at 1-second interval.
Repeat procedure beginning with Step 1) if clearance lights do not flash.

NOTE: If clearance lights operate repeating a 3-second on, 1-second off cycle, rain / light sensor may be abnormal. Perform diagnosis in this case.
Change position of adjustment knob in sequence of 5 → 1 → 5 within 4 seconds in the following procedure.

Fig 3: Identifying Adjustment Knob Positions

Courtesy of SUZUKI OF AMERICA CORP.

Check that clearance lights flash at 0.5-second interval and that flashing stops within 10 seconds.