LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Aux. Emission Control Devices >> Diagnostic Information and Procedures >> EVAP Leak Check Module Circuit Inspection >> EVAP Leak Check Pressure Sensor Circuit Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

EVAP Leak Check Pressure Sensor Circuit Check

  1. With ignition mode of keyless push start system in "OFF", connect SUZUKI scan tool to DLC.
  2. Push engine switch to change ignition mode of keyless push start system to "ON".
  3. Select "Data List" mode on SUZUKI scan tool.
  4. Check that displayed barometric pressure is specified value. Refer to "EVAP LEAK CHECK PRESSURE SENSOR (COMBINE WITH BARO SENSOR) ON-VEHICLE INSPECTION " under EVAP Leak Check Module Inspection  .

    If barometric pressure is within specified value, EVAP leak check pressure sensor and its circuit are in good condition.

    If barometric pressure is out of specification, check EVAP leak check pressure sensor, wire harness and connections.

scientia non olet · About LEMON Manuals