Learning Control Procedure
NOTE:
To perform the learning function normally, follow instructions below:
- When operating the select lever, hold it for more than 2 sec. in each position.
- Do not shift the select lever from "N" position to other positions until specified idle engine speed is obtained.
Cold condition
- Select "Data List" mode on SUZUKI scan tool.
- Cool down CVT fluid to ambient temperature.
- Start engine.
- Depress brake pedal fully and repeat shift operation from "N" range to "D" range, and from "N" range to "R" range 3 times for each gear shift. If excessive shift shock is observed, repeat this operation 10 times.
- Depress brake pedal fully at idle speed and hold in "D" range for 20 sec.
- Drive vehicle so that CVT fluid temperature reaches 40 °C (104 °F)
- Drive vehicle at 40 - 50 km/h (25 - 31 mile/h) constantly for 5 sec. in "D" range.
Hot condition
- Drive vehicle so that CVT fluid temperature reaches 80 °C (176 °F)
- Depress brake pedal fully and repeat shift operation from "N" position to "D" position and from "N" position to "R" position 3 times each. If excessive shift shock is observed, repeat this operation 10 times.
- Depress brake pedal fully at idle speed and hold in "D" position for 20 sec.
- Drive vehicle at 40 - 50 km/h (25 - 31 mile/h) constantly for 5 sec. in "D" position.