Error Codes
ERROR CODES CHART
| Code | Error | Condition | Correction/Reference item | |
|---|---|---|---|---|
| 51 | Sensor pulse error | Slide | Even after turning on power to motor, power seat control module does not receive pulses from motor's magnetic sensor for 1 second. | Check power seat control module circuit. Refer to INSPECTION OF POWER SEAT CONTROL SYSTEM AND ITS CIRCUITS (IF EQUIPPED) |
| 52 | Reclining | |||
| 53 | Lifter | |||
| 54 | Tilt | |||
| 61 | Switch input signal error | Slide | Signals are input from both positive (+) and negative (-) terminals of switches simultaneously. | Check driver power seat switch. Refer to SEAT SWITCH INSPECTION (IF EQUIPPED) |
| 62 | Reclining | |||
| 63 | Lifter | |||
| 64 | Tilt | |||
| 81 | Memory error (EEPROM) | Internal error of power seat control module is detected. | Disconnect power seat control module connector and recheck error code. Replace power seat control module if error code is recorded again. Refer to FRONT SEAT COMPONENTS | |
| 91 | Relay stuck error | Slide | Power voltage to each motor stays at MAX limit for longer than specified time. | Check power seat control circuit. Refer to INSPECTION OF POWER SEAT CONTROL SYSTEM AND ITS CIRCUITS (IF EQUIPPED) |
| 92 | Reclining | |||
| 93 | Lifter | |||
| 94 | Tilt | |||