Tightening Torque Specifications
NOTE:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Tensioner bolt | 25 | 2.5 | 18.5 |
| Idler pulley nut | 40 | 4.1 | 29.5 |
| Generator bolt* | 45 | 4.6 | 33.5 |
| "B" terminal nut | 11 | 1.1 | 8.5 |
| Bearing retainer screw | 2.3 | 0.23 | 2.0 |
| Pulley nut | 110 | 11.2 | 81.5 |
| Stator assembly bolt | 6.0 | 0.61 | 4.5 |
| Brush holder screw | 2.0 | 0.20 | 1.5 |
| Rear end cover nut | 4.5 | 0.46 | 3.5 |
NOTE:
The specified tightening torque is described in the following.
Reference:
For the tightening torque of fastener not specified in this section, refer to:
.