LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lighting Systems) >> Diagnostic Information and Procedures >> Reading Lamp(s) Inoperative >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reading Lamp Assembly Testing 

  1. Ignition OFF, disconnect the harness connector at the reading lamp assembly.
  2. Test for less than 2.0 ohms between the signal terminal and the ON terminal with the switch in the ON position.
    • If greater than 2.0 ohms, replace the reading lamp assembly.

Reading Lamp, Light Bulb Testing 

  1. Ignition OFF, remove the reading lamp bulb.
  2. Test for 1.0 to 4.5 ohms of resistance between the control terminal and the voltage supply terminal of the reading lamp bulb.
    • If the resistance is not within the specified range, replace the reading lamp bulb.
scientia non olet · About LEMON Manuals