LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Body Electrical Control System) >> Diagnostic Information and Procedures >> Body Electrical Control System Check >> Step 2: DTC Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Step 2: DTC Check

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Check DTC stored in BCM memory, see DTC Check .

In case that current DTC is detected: 

Perform applicable DTC troubleshooting for current DTC and repair or replace faulty parts.

In case that history DTC is detected: 

  1. Record DTC and then clear DTC once.
  2. Perform STEP 3: TROUBLE SYMPTOM CONFIRMATION .
  3. Referring to "CIRCUIT DIAGRAM " and "trouble area" in applicable diag. flow, confirm related parts where intermittent trouble is easy to occur (e.g., wire harness, connector, etc.) for detected history DTC.
  4. Check intermittent trouble, see REAR DRIVE SHAFT ASSEMBLY REMOVAL AND INSTALLATION .
    NOTE: Never perform diag. flow.

In case that there is no DTC: 

  1. Perform STEP 3: TROUBLE SYMPTOM CONFIRMATION .
  2. If there is "Symptom Diagnosis" procedure for any possible cause, perform corresponding "Symptom Diagnosis" procedure.
    NOTE: "Symptom Diagnosis" procedures for body electrical control system are described in each section.
scientia non olet · About LEMON Manuals