Procedure Actions
WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
Procedures in this Manual generally end with "Remove and Replace", "Remove and Install", or "Retrofit". These types of service are called "procedure actions", and they are defined as follows:
- Remove and Replace: Describes how to remove a part and replace it with a new part. These procedures sometimes contain steps that are not necessary if reinstalling the same part, such as transferring components from the original part to the new part.
- Remove and Install: Describes how to remove and reinstall the same part. These procedures are generally used when removing a part for access to another part in the vehicle.
- Retrofit: Describes how to install a new part on a vehicle that was not previously equipped with that part.
NOTE:
"Remove and Replace" is the default procedure action in this Manual. Unless a procedure has an equivalent "Remove and Install" procedure, the "Remove and Replace" steps should be used when reinstalling the same part.