LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Tesla >> 2018 >> Model X P100D >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering -- Model X >> Steering Rack And Lower Column >> Lock To Lock-Angle Test >> Test Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Test Procedure

  1. Enable Service Mode through the touchscreen. See SERVICE MODE .
  2. On the vehicle touchscreen, touch CAN Viewer  and select the signals STW_ANGLHP_STAT > StW_AnglHP  and EPAS_sysStatus > EPAS_torsionBarTorque  .
    NOTE: STW_ANGLHP_STAT > StW_AnglHP  can be found under CH  bus. EPAS_sysStatus > EPAS_torsionBarTorque  can be found under CH  bus on Intel MCU's, and under ETH  bus on Tegra MCU's.
  3. Turn the steering to the left lock stop and hold the EPAS_torsionBarTorque  value at 10 N.m while reading the angle. Record this value.
  4. Turn the steering to the right lock stop and hold the EPAS_torsionBarTorque  value at 10 N.m while reading the angle. Record this value.
  5. If the two angle values are more than 6 degrees apart, center the steering wheel. See STEERING WHEEL (REMOVE AND REPLACE) .
scientia non olet · About LEMON Manuals