Module - Restraint Control (Structural Pack) - Remove And Replace: Remove
WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
- Open the front doors and lower the front windows.
- Move the front passenger seat rearward.
- Remove the RH center console side panel. See SIDE PANEL - CENTER CONSOLE - LH (REMOVE AND REPLACE) .
- Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Remove the bolts (x2) that attach the HEPA filter assembly to the vehicle, and then remove the assembly from the vehicle.
Torque 5 Nm (3.7 lbs-ft)
NOTE: Pivot the rear edge of the assembly upward to clear the brake reservoir, and then lift the assembly upward to clear the underhood storage unit.Tip: Use of the following tool(s) is recommended:
- 10mm socket
- Disconnect LV power. See 12 V/LV POWER - DISCONNECT AND CONNECT
.WARNING: Make sure LV is disconnected before continuing to the next step.
- Disconnect the restraint control module connectors (x2).
- Remove and discard the nuts (x3) that attach the restraint control module to the vehicle.
Torque 8 Nm (5.9 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10mm socket
- Lift the restraint control module off the alignment studs, and then slide the module out from under the riser to remove it from the vehicle.