Bushing -- Front Drive Unit -- RH - Remove and Replace: Install

Set up the bushing tool to press in the new bushing.
NOTE: Use cups "L", "J", and "C" when assembling the special tool, as shown.

NOTE: Make sure the rubber tab is visible at the top of cup "J".

NOTE: Cups "L", "J", and "C" used to install the bushing

Courtesy of TESLA, INC.

NOTE: Rubber tab visible at the top of cup "J"

Courtesy of TESLA, INC.
Turn the bearing-side bushing tool nut with a wrench until the bushing flange makes contact with the front drive unit.
CAUTION: Apply torque only to the bearing-side bushing tool nut.

NOTE: While installing the bushing, make sure the rubber tab remains visible at the top of cup "J".

NOTE: Apply torque only to the nut highlighted red

Courtesy of TESLA, INC.
Separate the bushing tool, and then remove it from the drive unit.
Make sure the bushing alignment lug is oriented to 12 o'clock.
NOTE: Other assemblies hidden for clarity

Courtesy of TESLA, INC.
Install the front subframe assembly on the vehicle.
Check the vehicle wheel alignment, and adjust if necessary. See FOUR WHEEL ALIGNMENT CHECK .