Front Drive Unit Assembly - Bushing, RH, 3DUF - Remove And Replace: Install

Install the bushing press cups with a new bushing into position.
Use cups L, J and C to press the bushing into the front drive unit.
NOTE: When installing a new bushing, ensure the rubber tab is visible at the top of cup J. Always apply torque to the bearing side when removing or installing a bushing. Press the new bushing in until the flange on the bushing makes contact with the front drive unit case.

Tip: Use of the following tool(s) is recommended:
- Combination Wrench 12pt 22 mm
- Ratcheting Combination wrench Fixed head 22 mm
- Drive Unit Bushing Kit
Remove cups from the front drive unit, and inspect the alignment of the RH bushing.
Install the front subframe. See FRONT SUBFRAME - FRONT SUBFRAME ASSEMBLY - REMOVE AND REPLACE .