LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1998 >> RAV4 Base, 2D Utility, AWD, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing - 4-CYL >> Ignition Checks (DISTRIBUTORLESS Ignition System) >> Camshaft Position Sensor Resistance >> Tacoma, T100 & 4Runner
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Tacoma, T100 & 4Runner

  1. Disconnect electrical connector from camshaft position sensor. Camshaft position sensor is located at driver's side front corner of cylinder head, just in front of the intake manifold. See Figure-32. Using ohmmeter, check resistance between electrical terminals on camshaft position sensor.
  2. Ensure camshaft position sensor resistance is within specification. See CAMSHAFT POSITION SENSOR RESISTANCE  table. Replace camshaft position sensor if resistance is not within specification. See REMOVE/INSTALL/OVERHAUL article. Reinstall electrical connector on camshaft position sensor.
scientia non olet · About LEMON Manuals