Main Cruise Control Switch Circuit

WARNING: This page is about a different variant/trim than selected.

Remove cruise control ECU with harness connector attached. Turn ignition switch on. Using DVOM connected to chassis ground, backprobe cruise control ECU harness connector terminal No. 24 (Green/Black wire) with switch in specified positions. See MAIN CRUISE CONTROL SWITCH CIRCUIT SPECIFICATIONS table. If voltage reading is not as specified, go to next step. If voltage reading is as specified, fault may be intermittent. If sent here from SYMPTOM DIAGNOSIS, perform next test listed.

MAIN CRUISE CONTROL SWITCH SPECIFICATIONS

Switch Position	Volts
Off	7.5-14.0
On	0-1.5

Turn ignition off. Disable air bag system. See AIR BAG RESTRAINT SYSTEMS article. Remove steering wheel center pad (air bag module) and disconnect cruise control switch 6-pin connector. Check continuity between main cruise control switch connector terminals No. 3 (Black/Red wire) and No. 5 (Green/Black wire) with switch in specified positions. See MAIN CRUISE CONTROL SWITCH CONTINUITY table. If resistance is as specified, go to next step. If resistance is not as specified, replace main cruise control switch and retest system.

MAIN CRUISE CONTROL SWITCH CONTINUITY

Switch Position	Condition
Off	No Continuity
On	Continuity

Check wiring harness and connectors between cruise control ECU, cruise control switch and ground. Repair as necessary and retest system. If wiring harness and connectors are okay, go to next step.
Replace cruise control ECU. If input signals are as specified, no problem is indicated at this time. Fault may be intermittent. If sent here from SYMPTOM DIAGNOSIS, perform next test listed.