DTC P0441: EVAP Emission Control System Incorrect EVAP Purge Flow Or P0446: EVAP Emission Control System Vent Control Malfunction: Notes

WARNING: This page is about a different car, the 2003 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS .

CAUTION: If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. On models equipped with engine immobilizer, if ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - TOYOTA article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.

NOTE: If DTCs P0441, P0446, P0450 or P0451 is output after DTC P0440, perform appropriate test for these DTCs first before performing test for DTC P0440.