Inspection Procedure

HINT:

In case of using the hand-held tester, start the inspection from step  1 and in case of not using the hand-held tester, start from step  2.

1. Check headlight relay using hand-held tester. 

   PREPARATION: 

   Connect the hand-held tester to DLC 3.

   CHECK: 

   Check that the headlight relay operate in ACTIVE TEST (See PRE-CHECK ).

   1. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
   2. NG: Go to Next Step 
2. Check headlight relay circuit (See  INSPECTION  ). 
   1. NG: Replace engine room J/B assy with wire harness. 
   2. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ).